UEMS/WRF EMS Unofficial Forums

I always believed that the new ryzen and the new threadrippers could make a difference and be faster than the intel counterpart. I tried an overclocked Ryzen 3900x in the field, the results were great, but a much older xeon was still faster, equipped with slower ram etc. Maybe the new 39xx series th...

when i run the run now i am faced with this error III. Running WRF ARW while thinking happy thoughts * The WRF ARW core will use the following nodes and cores: 1 processors on servermaster (1 tile per processor) * A large time step of 75 seconds will be used for this simulation * Output Frequency Pr...

meteo60 wrote: ↑Mon Dec 28, 2020 12:05 pm What is your version please?

I use version 2.1.a3, every time I update uems, I replace the folder with my saved one again. the new versions of grads have given me several problems, with arpege for example there are further problems in reading gribs.

personally I have not yet understood how to run a simulation on a node, in the description you made it is not clear if you have uems installed on both pc, or only on one. Apart from setting ssh for communication without a password, I get the following questions: 1) is uems on both machines? 2) is th...

to me it works quietly, I don't have this problem. it depends on which version of grads you are using

ok with a little luck I did it. Now the PCs communicate on the network. I have a problem but when I go to run the simulation, I get an error, it probably can't communicate with the cpu

I'm trying to find the node on the network, through the terminal on the master pc I give the command netcheck node1


netcheck however does not exist on my system, as if it were not installed

in fact it gives me the error: netcheck: command not found

Hi everyone, I'm trying to figure out how to run uems in cluster. I have a server called "master" and one I called node1. The idea is to use node1 to run clustered uems, in the same local lan network. At the master pc I set an ip of this type: 192.168.1.200, while in the node I set ip 192....

I use opengrads 2.1 appositively and I find myself very well

Hello everyone, trying to use NMM I realized that returns artifact in the parameters of temperatures to 2 meters, but also in humidity. There are some areas of the domain that have negative values of different degrees below zero, when in reality the temperatures are far above zero. Same for humidity...