Page 1 of 1

ems_post grads ok?

Posted: Wed Apr 25, 2018 3:25 pm
by andres
Hi all,

I am testing V18.4.1 and all seems well until postprocessing. Converting to grib works fine but not to grad. Has anyone else got it working?
Not sure where is the problem, just nothing gets done in emsprd

Regards,

Andres

--
Geophysics Department
University of Concepcion, Chile

Re: ems_post grads ok?

Posted: Wed Apr 25, 2018 9:42 pm
by Canuck64
Sadly, the Grads Leins scripts no longer work as there was changes to the directory names. It will work if you go into the /util/grads/products/leins directory and run the wrfems2grads_wrapper.csh script directly.

Re: ems_post grads ok?

Posted: Thu Apr 26, 2018 12:32 pm
by andres
In this version of UEMS, there is no leins directory, just kumar and robert.

The missing step, since grads is installed, would be the conversion from NetCDF to GRADS. What part of the code use to do this?

Re: ems_post grads ok?

Posted: Fri Apr 27, 2018 11:56 pm
by Canuck64
Right, I had forgotten that Robert completely removed support for Leins in version 18 of the UEMS. I copied the version of Leins from my current version 15 of UEMS, to the version 18 utils directory.

In the post_uems.conf file for your domain, do you have both Grads and Grib set to Yes?

Re: ems_post grads ok?

Posted: Wed May 02, 2018 1:49 pm
by andres
In the post_uems.conf file for your domain, do you have both Grads and Grib set to Yes?
This is it. I only had Grads set to YES. Now I get the .ctl and .grb2 file, thanks