Data does not appear

Forum dedicated to older versions of EMS package (WRFEMS v3.2, v3.1 or older). Support is user-to-user based, so please help others if you can.
Post Reply
Curtis_Weatherman
Posts: 6
Joined: Tue Feb 05, 2013 1:26 am

Data does not appear

Post by Curtis_Weatherman » Tue Feb 05, 2013 1:30 am

I am running the WRF EMS using Centos 5.5 on VMWare. I run the WRF at 10km and everything runs fine. It writes the fields to the correct location. When I go to view the data, only the surface pressure has 24 hours worth of data that I can view. Every other parameter, 850mb temps, 300mb winds, all the other data only shows at 00 hours, its black with no data as I progress through the hours. What would be causing this and what is a recommended fix to try and resolve? Thanks!!!!

meteoadriatic
Posts: 1574
Joined: Wed Aug 19, 2009 10:05 am

Re: Data does not appear

Post by meteoadriatic » Tue Feb 05, 2013 8:23 am

Hello,

in what software you view the data?

Curtis_Weatherman
Posts: 6
Joined: Tue Feb 05, 2013 1:26 am

Re: Data does not appear

Post by Curtis_Weatherman » Tue Feb 05, 2013 2:01 pm

I pull up gempak in vmware and then download the wrf data from there. I try to view it in nmap as it was set up to do.

meteoadriatic
Posts: 1574
Joined: Wed Aug 19, 2009 10:05 am

Re: Data does not appear

Post by meteoadriatic » Tue Feb 05, 2013 2:10 pm

I personally don't have experience with that software.

Do you know to do anything in GrADS, at least to check out if that works?

Curtis_Weatherman
Posts: 6
Joined: Tue Feb 05, 2013 1:26 am

Re: Data does not appear

Post by Curtis_Weatherman » Tue Feb 05, 2013 2:20 pm

No I do not

Post Reply